Here is my lovely little box - one of my customers set me a challenge to make a box from one sheet A4 card with a top folding closure and here it is :-) It has matching papers and the top bow is made from the envelope punch board to create the neat little bow.
Here are the instructions if anyone wants to make one..
On
short side – score at 6 cm then turn over and score other side at
6 inches
On
long side – score at 7 - 13 - 20 - 26 cm
Cut
off the small ends and the next square at one end and cut the 3 side
squares to the fold trimming a bit off the middle square flap at the
sides.
Fold
in to make the box and secure the sides with red-line tape
DSP
papers are as below
1
piece measuring 8.5 cm x 5.5 cm (lid)
2
pieces measuring 8.5 cm x 6.5 cm (front & back)
2
pieces measuring 5.5 cm x 6.5 cm (ends)
****
Decorate
using the Envelope Board to make a pretty bow using card or DSP.
1
piece at 1 inch x 6 inches
1
piece at 1 inch x 4 inches
1
piece at 1 inch by ¼ inch
Put
the 6 inch piece on board and score at 3 inches turn over and repeat
put
the end so in the middle of cutting semi circle and punch, turn and
repeat then do the same at the other end
put
the 4 inch piece on board and punch at 2 inches, turn round and
repeat
put
the end piece with short side into cutting place half way in and
punch, repeat other end.
Place
the 4 inch piece on table and then fold the end tabs to the centre on
the 6 inch piece stick down and wrap the ¼ inch piece around to make
a band.. stick onto 4 inch piece with a dimensional and glue dot a
button to decorate the top... stick onto top of box.
Products used to make this project...
Table built using Product Table Builder by The Crafty Owl - Independent Stampin'
Up! Demonstrator.
also used buttons and papers from the Sale-a-bration booklet
also used buttons and papers from the Sale-a-bration booklet
Thanks for looking at my blog today - Jo.